Wheel Alignment in Clarksville, IN

Wheel alignment in Clarksville on a Hunter HawkEye Elite

The same alignment system the big dealer service departments run: four cameras, a measurement in about 70 seconds, and a before-and-after printout you take home. Fix the pull, stop eating tires.

Signs the alignment is off

An alignment problem rarely feels dramatic. It shows up in the tires and the steering wheel.

Pulls to one side on a flat roadCamber or caster is uneven side to side. Rule out tire pressure first; if it still pulls, align it.Book this week
Steering wheel is off-centerToe is uneven between the two front wheels. Common after a pothole or curb hit.Book this week
Inside or outside tire edge wearing fastCamber or toe out of spec. Each month out of alignment costs tire life you paid for.Book this week
New tires, new suspension, or a hard potholeAlignment protects the new parts. A hit hard enough to bend something changes the angles.Book soon

What a Cooper alignment includes

Measure, inspect, adjust, verify. In that order.

  • Steering and suspension inspection before alignment, because worn parts cannot hold an adjustment
  • Tire pressures set and ride height checked
  • Four-wheel measurement on the Hunter HawkEye Elite: camber, caster, toe and thrust angle at every wheel
  • Adjustments to factory specification, front and rear where the vehicle allows
  • Steering wheel centered and a printed before-and-after report

About the Hunter HawkEye Elite

Hunter builds the alignment equipment most dealer service departments standardize on. The HawkEye Elite is their top system.

  • Four high-resolution cameras read targets on each wheel
  • QuickGrip adaptors clamp the tire, not the rim, so wheels are not scratched
  • Full four-wheel measurement in about 70 seconds
  • Specifications for cars, trucks and SUVs updated by Hunter, so the targets are current for your model

How a visit goes

Three steps, no surprises. You approve the quote before a wrench moves.

  1. Tell us what you notice

    Pull, off-center wheel, tire wear, or just new tires. If you hit something, say so; it changes where we look.

  2. We inspect, then measure

    Tie rods, ball joints, bushings and bearings get checked first. Then the car goes on the HawkEye and you see the before numbers.

  3. Adjust, verify, print

    We set the angles to spec, re-measure, and hand you a printout showing before and after at each wheel.

Two-wheel or four-wheel?

Almost every car and crossover built in the last twenty years has adjustable or at least measurable rear alignment. We measure all four wheels every time; adjusting the rear depends on the vehicle.

  • Four-wheel alignment. Front and rear measured and adjusted. The standard for cars, crossovers and most SUVs.
  • Thrust-angle alignment. For solid-rear-axle trucks: the fronts are aligned to the direction the rear axle actually points.
  • After new tires. A new set is the best time to align, so the new tread wears flat from day one.
  • After suspension work. Struts, tie rods, control arms and ball joints change the angles. Alignment finishes the job.

Questions we get about this service

How often should I get a wheel alignment?

Once a year is a good rhythm for most drivers, and any time you buy tires, replace suspension or steering parts, or hit a pothole or curb hard enough to feel it in the wheel. If the car pulls or the wheel sits off-center, do not wait for the anniversary.

How long does a wheel alignment take?

The HawkEye Elite measures all four wheels in about 70 seconds. The full visit, including the suspension inspection, adjustment and verification, is usually about an hour. Seized adjusters on older or rust-prone vehicles can add time; we tell you before continuing.

Will an alignment fix a vibration?

Usually not. Vibration at speed is almost always tire balance, a bent wheel or a worn part. Alignment fixes pulling, off-center steering and uneven tire wear. If you have both, we balance and align in the same visit.

Can you align a lifted or lowered truck?

Yes. The HawkEye Elite handles lifted and lowered vehicles, and we align them to the specification appropriate for the setup. Tell us about the lift kit or lowering when you book.

What is on the printout?

Camber, caster, toe and thrust angle for each wheel, before and after, with the factory range shown in green. It is a record for you and a check on us.

More answers in the Cooper FAQ

Visit Cooper Automotive in Clarksville

Part of Craig and Landreth Auto Group. Same equipment the dealer service departments use, without the dealer markup.

  • Quote first. You see the number and approve it before any work starts.
  • Any make. Domestic and import cars, trucks and SUVs, including most diesels.
  • Dealer-grade tools. Hunter HawkEye Elite alignment and factory-level diagnostics.
  • Easy to reach. On Eastern Blvd in Clarksville, minutes from Jeffersonville, New Albany and the Louisville bridges.

Cooper Automotive

Hours
Mon–Fri 9:00 am–5:00 pm. Closed Sat and Sun